Teensy 3 programing without using USB port

Status
Not open for further replies.

NelsonFdT

New member
Hello.

My name is Nelson and I'm from Portugal. This is my first post in this forum.
As a electronics interested guy, I bought a few weeks ago a Teensy 3.0 board, to do some projects.
Unfortunately, in the first time that I connected my Teensy board to my computer using a Micro USB cable, Teensy began to smoke and I didn't had anything connected to it (not even Vcc or GND). I don't know what happened but inspecting the board, I see that Ferrite Bead was burned. I installed the drivers on Windows 7 and on XP, but only what I get is "Unknown device" and I tried many many times in different PCs, using different USB cables.

But when I connect the board only to the Vcc and GND I saw Led blinking (USB not connected). If I connect only to USB, nothing happens as I mentioned earlier.

So my question is, can I program my Teensy without using the USB or there is anything that I can do to save my Teensy board? I ask this because I think that MK20 is working fine.

Regards,
Nelson
 
Status
Not open for further replies.
Back
Top