I've been using nrf24l01+ modules to communicate between two arduino unos but I found that arduino was too slow to do the things I wanted on one end.
I tried the same code with Teensy 3.0 and the result was spectacular!
But I was wondering if it is possible to communicate between an Arduino Uno and a Teensy using the wireless module I specified. If that is not possible, how could I send commands from one Arduino Uno to Teensy? I know that if I use RX and TX, whenever arduino boots up, the board becomes unstable and cannot boot. I need an alternative.
I tried the same code with Teensy 3.0 and the result was spectacular!
But I was wondering if it is possible to communicate between an Arduino Uno and a Teensy using the wireless module I specified. If that is not possible, how could I send commands from one Arduino Uno to Teensy? I know that if I use RX and TX, whenever arduino boots up, the board becomes unstable and cannot boot. I need an alternative.