snskreationz
New member
Hi,
I got the 2x teensy 3.1 today in the mail, and from my experiences with the previously bought teensy 3.0, I am very happy with your products.
I just do have a few of concerns.
1) Is there going to be a teensy 3.1++ that has the pins like the teensy 2.0++ because those pins at the underside are hard to get to. I am just curious because I tend to run out of pins sometimes.
2) Is the 3.3v next to VBat an output?
3) I notice that there is no PID library or fuzzy logic libraries written for the teensy. I used have a little experience with assembly, and I would just like to know where would be a good start for compiling and programming this chip outside arduino IDE. Also if there are any tutorials or books for compiling/programming/etc available can you please direct me?
Thank you.
I got the 2x teensy 3.1 today in the mail, and from my experiences with the previously bought teensy 3.0, I am very happy with your products.
I just do have a few of concerns.
1) Is there going to be a teensy 3.1++ that has the pins like the teensy 2.0++ because those pins at the underside are hard to get to. I am just curious because I tend to run out of pins sometimes.
2) Is the 3.3v next to VBat an output?
3) I notice that there is no PID library or fuzzy logic libraries written for the teensy. I used have a little experience with assembly, and I would just like to know where would be a good start for compiling and programming this chip outside arduino IDE. Also if there are any tutorials or books for compiling/programming/etc available can you please direct me?
Thank you.