Eclipse Arduino IDE - Error <> is not compiled for this board Teensy 3.0 vs 3.1
Hi,
kudos to Jantje for Eclipse Arduino IDE and thanks to headroom for instructions pages. I've finally gotten all of the steps done and I appear to be able to build the blink example. I'm developing on Ubuntu 12.04.
However, when i try to upload Teensy bootloader complains
Error: "blink.hex" is not compled for this board.
Compiled for: "Teensy 3.0 (MK20DX128)"
This board is: "Teensy 3.1 (MK20DX256)"
I noticed in .../teensy/all/boards.txt there is no specific mention of teensy 3.1, so I tried making the following changes:
o changed "teensy3.name=Teensy 3.0" to "teensy3.name=Teensy 3.1"
o all occurrences of 128 to 256, where it appeard in MK20DX<> string.
But this did not seem to have any affect.
Any suggestions? Thanks in advance.
How in general, do I convert this setup from teensy 3.0 to teensy 3.1, even though they are supposedly code compatible?
Thanks
Hi,
kudos to Jantje for Eclipse Arduino IDE and thanks to headroom for instructions pages. I've finally gotten all of the steps done and I appear to be able to build the blink example. I'm developing on Ubuntu 12.04.
However, when i try to upload Teensy bootloader complains
Error: "blink.hex" is not compled for this board.
Compiled for: "Teensy 3.0 (MK20DX128)"
This board is: "Teensy 3.1 (MK20DX256)"
I noticed in .../teensy/all/boards.txt there is no specific mention of teensy 3.1, so I tried making the following changes:
o changed "teensy3.name=Teensy 3.0" to "teensy3.name=Teensy 3.1"
o all occurrences of 128 to 256, where it appeard in MK20DX<> string.
But this did not seem to have any affect.
Any suggestions? Thanks in advance.
How in general, do I convert this setup from teensy 3.0 to teensy 3.1, even though they are supposedly code compatible?
Thanks