Forum Rule: Always post complete source code & details to reproduce any issue!
Results 1 to 1 of 1

Thread: [ TEENSY3.1, using the 2 ADCs in single ended 16 bits mode ]

  1. #1
    Junior Member
    Join Date
    Apr 2013
    Posts
    13

    [ TEENSY3.1, using the 2 ADCs in single ended 16 bits mode ]

    Hi,

    I am designing a TEENSY3.x carrier board for a project which
    measures 2 voltages. I saw that the TEENSY3.1 has 2 independent
    ADCs, and I will use them both so that measured voltages are sort
    of synchronized.

    I also want the carrier board to support TEENSY3.0, using ADC0
    channels multiplexing.

    I ended up using A1 and A2 (ADC0_SE14 and ADC{0,1}_SE8).
    Can anyone confirm there is no limitation in doing so ? Can I use
    both ADCs channels with a single ended 16 bits resolution ?

    I was sure that only SOME channels could be used in 16 bits mode,
    but I can not find a trace of such a limitation in the documentation ...
    I must have dreamed, but prefer to ask before sending the PCB :/

    Thanks for helping,

    t.

    I have found every information I need from this post:
    http://forum.pjrc.com/threads/407-Te...highlight=aref
    Last edited by texane; 03-16-2014 at 08:46 PM. Reason: solved

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •