OCTOWS2811 Moving Pin4 to Pin17 Possible?

Status
Not open for further replies.

johnnyfp

Well-known member
I don't 100% understand the DMA mapping to corresponding ports, but from the Datasheet I can see that Pin4 or FTM1_CH1 is also available on Pin17. Is it possible to update the Octo library to move the DMA trigger from Pin4 to Pin17?

Thanks
 
Sorta.

I've put together a new teensy, called a weensy :) Basically a teensy with a CC3000 and SD socket. But I used pin 4 for CS to the wifi module. Rather than move the hardware, I want to see if I can do it in software. If not, just means I have to respin the boards.
 
Status
Not open for further replies.
Back
Top