Chopsticks
Active member
Teensy 3.1: ADC PINS / 16-Bits mode
Hi there,
Maybe a dumb question, i've been watching this pin layout from the Teensy 3.1 (see link) http://www.pjrc.com/teensy/card5a_rev5.pdf
In the datasheet of the processor are the pins located on pin 9 and 10 (PGA0_DM/ADC0_DM0/ADC1_DM3 (9) and PGA1_DP/ADC1_DP0/ADC0_DP3 (10)), but what are the pins on the Teensy 3.1 Board? It confuses me a little bit, haha.
I ordered my Teensy 3.1 a few days ago. But i'm already busy with creating a custom pcb. But have no clue what the correct pins are.
i want to convert two signals at the same time on two 16-bits channels. So, what are the two pins that i need?
kind regards,
Klaas
Hi there,
Maybe a dumb question, i've been watching this pin layout from the Teensy 3.1 (see link) http://www.pjrc.com/teensy/card5a_rev5.pdf
In the datasheet of the processor are the pins located on pin 9 and 10 (PGA0_DM/ADC0_DM0/ADC1_DM3 (9) and PGA1_DP/ADC1_DP0/ADC0_DP3 (10)), but what are the pins on the Teensy 3.1 Board? It confuses me a little bit, haha.
I ordered my Teensy 3.1 a few days ago. But i'm already busy with creating a custom pcb. But have no clue what the correct pins are.
i want to convert two signals at the same time on two 16-bits channels. So, what are the two pins that i need?
kind regards,
Klaas
Last edited: