Teeny USB connector repair
Hi I have a teensy 3.1 that I squeezed into a tight fitting case, and upon removal the micro usb connector ripped off . I believe it still works fine - is it possible to program this teensy without the use of the USB board? For example I remember reading somewhere about using another teensy 3 and I2C to program it perhaps?
edit: turns out repairing the connector directly is the best route
Thanks
Don
Hi I have a teensy 3.1 that I squeezed into a tight fitting case, and upon removal the micro usb connector ripped off . I believe it still works fine - is it possible to program this teensy without the use of the USB board? For example I remember reading somewhere about using another teensy 3 and I2C to program it perhaps?
edit: turns out repairing the connector directly is the best route
Thanks
Don
Last edited: