Teensy 3.1 Breakout updated -- 25% discount for PJRC forum members

Status
Not open for further replies.
I was hoping to see the switch installed as the pads for it aren't obvious.

This is where the switch goes:

circled.jpg
 
Just a note to say I received my boards today and am really impressed with the super-fast shipping and communication you've provided here. Haven't put the kits together yet, but "nicely done" I'd say.
Matt
 
Just a note to say I received my boards today and am really impressed with the super-fast shipping and communication you've provided here. Haven't put the kits together yet, but "nicely done" I'd say.

Thanks very much!

Let me know if you have any questions or issues or suggestions (or any feedback really).
 
I like the new card, and the revision C board with the option of a switch makes it easier to optionally disconnect VIN from VUSB. The position of the VUSB pin is a lot better than the previous board.
 
Status
Not open for further replies.
Back
Top