Hello,
I have been happily using my Teensy 3.1. During a recompile I purposed disconnected the USB (to stop the compile), for a reason that isn't important for this thread.
Now that I did that, I cannot seem to compile anymore. The board is not showing up in my Serial Port. I attempted to reboot my computer (MAC 10.9.5) and replug the board while holding down the program button. Matter of fact, doesn't seem like the hitting the program button does anything.
Each time I compile I am prompted with:
"
Please press the RESET BUTTON on your Teensy to upload your sketch. Auto-reboot only works if the Teensy is running a previous sketch.
"
Any suggestions to get this thing up and running again?
Daniel
I have been happily using my Teensy 3.1. During a recompile I purposed disconnected the USB (to stop the compile), for a reason that isn't important for this thread.
Now that I did that, I cannot seem to compile anymore. The board is not showing up in my Serial Port. I attempted to reboot my computer (MAC 10.9.5) and replug the board while holding down the program button. Matter of fact, doesn't seem like the hitting the program button does anything.
Each time I compile I am prompted with:
"
Please press the RESET BUTTON on your Teensy to upload your sketch. Auto-reboot only works if the Teensy is running a previous sketch.
"
Any suggestions to get this thing up and running again?
Daniel