* Warning, this post can contains bad english *
Hi all !
I think that I have a big problem now.
Firstly, I broke the pre-installed micro-usb port.
I tired to resolder another but grey squares (sorry I don't know what it is) where tin is, disappeared. (maybe I let the soldering iron too much time on the board)
So, I saw the second way to program Teensy under the board (VUSB, D+, D-, GND).
But ... I did the same mistake : grey square of D+ disappeared too.
Anyone as a way to repair this ? Program Teensy by another way or repair "grey squares" ?
Thanks in advance,
Yeko
Hi all !
I think that I have a big problem now.
Firstly, I broke the pre-installed micro-usb port.
I tired to resolder another but grey squares (sorry I don't know what it is) where tin is, disappeared. (maybe I let the soldering iron too much time on the board)
So, I saw the second way to program Teensy under the board (VUSB, D+, D-, GND).
But ... I did the same mistake : grey square of D+ disappeared too.
Anyone as a way to repair this ? Program Teensy by another way or repair "grey squares" ?
Thanks in advance,
Yeko
Last edited: