Dear Paul,
First i well recieve my package after one month and half (that's the way when you live in a tropic island)
Since two hours now i'm trying to upload simple "blink" sketch on my boards (i've got to of Teensy 3.1) with Arduino 1.0.6 IDE installed.
I followed the tuto to install teensyduino 1.22 then open "blink" sketch, selected "teensy 3.1" board, i can' choose any serial port so i choose "RawHID" as USBtypeSerial.
I change the LED off delay to show the difference between blink onboard programme and mine.
Click on "Upload", arduino start compiling then upload and then tell me that "Done Uploading" but nothing change, the LED is still blinking 1s ON, 1s OFF.
I would like to know if i'm wrong but i believe that i should choose a serial port to upload sketch.
I testedboth board and i've got the same result
Please could you help to solve this ?
Best regards,
xarolium
First i well recieve my package after one month and half (that's the way when you live in a tropic island)
Since two hours now i'm trying to upload simple "blink" sketch on my boards (i've got to of Teensy 3.1) with Arduino 1.0.6 IDE installed.
I followed the tuto to install teensyduino 1.22 then open "blink" sketch, selected "teensy 3.1" board, i can' choose any serial port so i choose "RawHID" as USBtypeSerial.
I change the LED off delay to show the difference between blink onboard programme and mine.
Click on "Upload", arduino start compiling then upload and then tell me that "Done Uploading" but nothing change, the LED is still blinking 1s ON, 1s OFF.
I would like to know if i'm wrong but i believe that i should choose a serial port to upload sketch.
I testedboth board and i've got the same result
Please could you help to solve this ?
Best regards,
xarolium