AverageGuy
Well-known member
Never mind, I realized too late the device doesn't appear until after a compile. And I can't figure out how to delete a post.
Last edited:
Right, sorry for wasting your time.EDIT: oh well. At least you know why it did that.
I think Paul switched the default firmware to Raw HID some time ago, to avoid issues when plugging the Teensy into Windows before installing the serial "driver".
Yup. This change was in January 2014.
But if you're used to the Arduino paradigm where everything is a COM port (Windows) or serial device (Linux, Mac), it can cause confusion. So far, this way seems to be the best I've found to help the most people. It seems there's no perfect way for everyone.
What steps can I take to get my 3.2s to enumerate as ttyACM0 and behave as before?
FYI, I use cmake and netbeans IDE. I use teensyduino loader to deploy updated code. I have test driver
pgms and cutecom to monitor debug output on /dev/ttyACM*.
... but I just got some teensy 3.2s in and they enumerate on linux as "hidraw*".