epicycloid
Well-known member
Maybe you can use something like this flat (1.5mmwide x 0.2mmthick) pretinned copper solar panel tabbing wire to bring the relocated Teensy 3.2 reset signal over to the solder point on the Rev2 HWGuy breakout board.
http://www.ebay.com/itm/100-feet-TABBING-WIRE-for-Solar-Cell-DIY-Pre-soldered-/171859110829
Yes, that's exactly what I was planning to do, just pre-tin my own copper strip. But now I know it's officially called "tabbing wire". Thanks.
Sullins Connector Solutions PREC040SABN-RC (digikey: S1022EC-40-ND)
head: 5.84 mm
tail: 5.84 mm
contact surface: tin overall
In my oshpark pictures, head & tail are 6.2mm and that's a bit too long. It seems that something like 5.08mm (0.2 inch) would be the optimal length.
Updated version of the adapter board for Teensy 3.2: oshpark and image. The board is not tested and at the moment I have no plans to order one.
The Sullins headers look perfectly fine. Thanks for finding those. The tops can just be trimmed once soldered, so longer there is ok.
Thank you also for the update on the board. I'll order some and be the guinea pig.