dead teensy 2++?

Status
Not open for further replies.
S

srusha

Active member
Hello

I have teensy 2++ that was working perfectly fine until it just stopped, for no reason, it was connected to a seed studio gprs 2 shield and stable 5v that came from a computer usb,

It appears that the computer doesn't detect it and I cant seem to upload anything to it, moreover, it seems to be heating up a bit when I am connecting it to the computer.

Any ideas what I could do to try and revive it?

Thanks
 
I apparently have the same issue when I received the Teensy the onboard led blinked. After uploading a sketch it stopped and the sketch uploads. But no output went back to Arduino Library and uploaded the blink program onboard LED light is not responding. I only read 1 volt between the GND and the 5+ pin. Thanks.
 
Status
Not open for further replies.
Back
Top