I seem to have just messed up my second Teensy. I can no longer upload to it. This one is a Teensy 3.2. My order was "211407" on 9/29/2015.
I had asked before whether or not I was placing too much load on the board. I am unable to attach a copy of the documentation for my project. It is a lengthy word document. You can get a copy off my github https://github.com/mboroff/Repeater_Controller.git.
Page 7 has the wiring diagram. The construction section is a step by step following of how I put it together. Figure 15 on page 14 is missing. I forgot to make it. But simply the Teensy 3.2 is sitting on 14 pin female headers solder to the board.
Adafruit is suppose to replace the first Teensy 3.1, if they get one in (I have told them they have been replaced but they don't list the 3.2 yet). You advised me on a previous post on this one getting very hot when I plug in the usb cable.
The Teensy 3.2 for this issue does not get hot just a little warm. It just won't upload.
So my question is do I have a design flaw in my design that you can determine? I have used this design with an ATMEG2560 and not experienced any problems with voltages or heat.
Thanks for looking.
I had asked before whether or not I was placing too much load on the board. I am unable to attach a copy of the documentation for my project. It is a lengthy word document. You can get a copy off my github https://github.com/mboroff/Repeater_Controller.git.
Page 7 has the wiring diagram. The construction section is a step by step following of how I put it together. Figure 15 on page 14 is missing. I forgot to make it. But simply the Teensy 3.2 is sitting on 14 pin female headers solder to the board.
Adafruit is suppose to replace the first Teensy 3.1, if they get one in (I have told them they have been replaced but they don't list the 3.2 yet). You advised me on a previous post on this one getting very hot when I plug in the usb cable.
The Teensy 3.2 for this issue does not get hot just a little warm. It just won't upload.
So my question is do I have a design flaw in my design that you can determine? I have used this design with an ATMEG2560 and not experienced any problems with voltages or heat.
Thanks for looking.