JarkkoL
Well-known member
Hi,
I have a situation where I need to solder a 4 pin connector to back of Teensy LC: pin 12, pin 17, 3.3V and GND. However, I need either of the output pins to support PWM, so I though of connecting Pin 20 to Pin 17. Is there a way to disable a pin, i.e. I would like Pin 17 to "hang in air"?
Thanks, Jarkko
I have a situation where I need to solder a 4 pin connector to back of Teensy LC: pin 12, pin 17, 3.3V and GND. However, I need either of the output pins to support PWM, so I though of connecting Pin 20 to Pin 17. Is there a way to disable a pin, i.e. I would like Pin 17 to "hang in air"?
Thanks, Jarkko