I was working on a project with my teensy adding a psp controller. Well everything was going ok until I uploaded a code that was incorrect. Well I happened to look over and my ground pin for the teensy was floating and possibly making contact with a resistor. Now when trying to upload a program it acts like everything is fine except that its not uploading the code. And after a few seconds it comes back with teensy did not respond to a usb based request to reboot. Is it possible that the ground pin broke the teensy?
Is it broke
- Thread starter agrizzle
- Start date
- Status
defragster
Senior Member+
If it isn't try the steps and code in this post and it may bring joy: https://forum.pjrc.com/threads/Can-t-communicate-with-Teensy
Hopefully you just got it in an odd state - as I did to mine before documenting what I was doing to bring it back.
Hopefully you just got it in an odd state - as I did to mine before documenting what I was doing to bring it back.
- Status