ChrisLaurie
Member
I'm having some problems when combining these 2 libraries. I am not using Octows2811 because of the additional functionality (hue, wave functions and text mostly) that FastLED gives me.
On my teensy 3.2 I get the led's to display perfectly when there is no dmx data on the line. That is the dmx ISR is started but there is no DMX data to read. The moment I get dmx data and switch from demo mode control to dmx control, the pixels go beserk. I can see the correct dmx values being read and the correct (same) procedures started, bit the led's light up and flicker randomly. It looks as if the unerlying display did happen but the flickering is intense and a lot. It seems to cover the initial half of the strip which is arranged in a matrix of 35 x 7.
I suspect there are interrupt issues but I have tried everything I could think of and tried quite a few ideas gleaned form this forum but to no avail. Previously I used the DmxReceiver and OctoWs2811 together quite efficiently.
Anyone has any ideas for me?
On my teensy 3.2 I get the led's to display perfectly when there is no dmx data on the line. That is the dmx ISR is started but there is no DMX data to read. The moment I get dmx data and switch from demo mode control to dmx control, the pixels go beserk. I can see the correct dmx values being read and the correct (same) procedures started, bit the led's light up and flicker randomly. It looks as if the unerlying display did happen but the flickering is intense and a lot. It seems to cover the initial half of the strip which is arranged in a matrix of 35 x 7.
I suspect there are interrupt issues but I have tried everything I could think of and tried quite a few ideas gleaned form this forum but to no avail. Previously I used the DmxReceiver and OctoWs2811 together quite efficiently.
Anyone has any ideas for me?