If you read the questions and answers at the end of the amazon page it is this LCD
http://www.lcdwiki.com/3.5inch_RPi_Display
Features
320×480 resolution
Resistive touch control
Supports any revision of Raspberry Pi (directly-pluggable)
Compatible with Raspberry Pi A, B, A+, B+, 2B, 3B, 3B+,4B versions
Drivers provided (works with your own Raspbian/Ubuntu directly)
Size perfectly fits the Pi
High quality immersion gold surface plating
Supports Raspbian system, ubuntu system ,kali Linux system
Key Parameters
SKU MPI3501
LCD Type TFT
LCD Interface SPI(Fmax:32MHz)
Touch Screen Type Resistive
Touch Screen Controller XPT2046
Colors 65536
Driver IC ILI9486
Backlight LED
Resolution 320*480 (Pixel)
Backlight Current 120ma
Power Dissipation 0.13A*5V
Operating Temp. (℃) -20~60
Active Area 48.96x73.44(mm)
Product Size 85.42*55.60(mm)
Package Size 118*72*34 (mm)
Rough Weight(Package containing) 75 (g)
Interface
PIN NO. SYMBOL DESCRIPTION
1, 17 3.3V Power positive (3.3V power input)
2, 4 5V Power positive (5V power input)
3, 5, 7, 8, 10, 12, 13, 15, 16 NC NC
6, 9, 14, 20, 25 GND Ground
11 TP_IRQ Touch Panel interrupt, low level while the Touch Panel detects touching
18 LCD_RS Instruction/Data Register selection
19 LCD_SI / TP_SI SPI data input of LCD/Touch Panel
21 TP_SO SPI data output of Touch Panel
22 RST Reset
23 LCD_SCK / TP_SCK SPI clock of LCD/Touch Panel
24 LCD_CS LCD chip selection, low active
26 TP_CS Touch Panel chip selection, low active
Driver Installation
This LCD Module need install driver first.
Step 1:Download the Raspbian IMG
https://www.raspberrypi.org/downloads/raspbian/
Step 2: Burn the system image
If you don't know how to do that,you can refer to the Raspberry Pi office tutorial
Step 3: Open terminal(SSH) and install the driver on RaspberryPi
(tested on RaspberryPi 3B+,3B,2B,2B+,1B,ZERO)
Run:
sudo rm -rf LCD-show
git clone
https://github.com/goodtft/LCD-show.git
chmod -R 755 LCD-show
cd LCD-show/
sudo ./LCD35-show