Hi there!
I have 2xT3.2+audio shield (16bit 44.1kHz) and 2xRF24 using the RF24 library which works for sending digital messages.
My question is how to get the direct 16bit data from the audioshield to put it in the radio.write line for the RF24 transmitter ?
And then on the receiver side how can I do to send the 16bit data from the receiver into the audio shield for getting analog output? Is this possible to do?
I've been searching in the SPI library but have not found a command to get the raw 16bit data from the audio codec.
Many thanks!!
YC
I have 2xT3.2+audio shield (16bit 44.1kHz) and 2xRF24 using the RF24 library which works for sending digital messages.
My question is how to get the direct 16bit data from the audioshield to put it in the radio.write line for the RF24 transmitter ?
And then on the receiver side how can I do to send the 16bit data from the receiver into the audio shield for getting analog output? Is this possible to do?
I've been searching in the SPI library but have not found a command to get the raw 16bit data from the audio codec.
Many thanks!!
YC