luizrrocha
Member
Hi Paul,
Always thanks for the fantastic work.
I am using an old and trysty Teensy 3.1 as a home energy monitor using eMonLib as a basis. It monitors 3 mains phases (Voltage and Current) and 6 output circuits (Current), using Pedvide's ADC to speed things up.
Now I need to integrate it with my Domoticz installation which runs on a MySensors mesh network which does not support Teensy at all. Can you take a look at this library to see how difficult it would be to add Teensy support for it ? It runs mainly on Arduinos so I feel that the extended capabilities of the Teensy architecture would enable the development of more capable sensors such as the one I am building right now. There were calls in the past in the library forum for other platforms, Teensy included (https://forum.mysensors.org/topic/529/sam-architecture-due-teensy-3) but did not go further.
Perhaps you would prefer to assemble a team of other interested Teensy and MySensors users to do the conversion job with your support. I would like to be part of it.
The information on the library:
Github link ==> https://github.com/mysensors
Home Page ==> https://www.mysensors.org/
Best regards,
Luiz Roberto Rocha
Rio de Janeiro
Brazil
Always thanks for the fantastic work.
I am using an old and trysty Teensy 3.1 as a home energy monitor using eMonLib as a basis. It monitors 3 mains phases (Voltage and Current) and 6 output circuits (Current), using Pedvide's ADC to speed things up.
Now I need to integrate it with my Domoticz installation which runs on a MySensors mesh network which does not support Teensy at all. Can you take a look at this library to see how difficult it would be to add Teensy support for it ? It runs mainly on Arduinos so I feel that the extended capabilities of the Teensy architecture would enable the development of more capable sensors such as the one I am building right now. There were calls in the past in the library forum for other platforms, Teensy included (https://forum.mysensors.org/topic/529/sam-architecture-due-teensy-3) but did not go further.
Perhaps you would prefer to assemble a team of other interested Teensy and MySensors users to do the conversion job with your support. I would like to be part of it.
The information on the library:
Github link ==> https://github.com/mysensors
Home Page ==> https://www.mysensors.org/
Best regards,
Luiz Roberto Rocha
Rio de Janeiro
Brazil