Using Teensy 3.6 with non-Arduino software?

Status
Not open for further replies.

ivoras

New member
Hello,

I've seen in this forum that the Teensyduino / the Arduino core for Teensy boards will most likely never support the USB MSC mode, so I'm wondering if anyone has experimented with using the board with official NXP software tools (I think it's called MCUXpresso), or some other low-level-ish tools which can do that?

Yup, I'm specifically asking about the mass storage class, not MTP and such.

I very much like the Teensy 3.6 board layout, it's just that I need MSC.
 
Status
Not open for further replies.
Back
Top