laptophead
Well-known member
The usual "Serial" works fine on my desktop, however I am using it to send data to the teensy by Serial Monitor.
So I need to monitor the behavior of my motors and encoders through SerialPlotter or processing. Therefore I need another USB port just for that , and I selected 5, since is not wired to any of my needs.
From the laptop USB I brought Plus Minus, RX TX and connected them accordingly. RX and TX go to 34 and 33. However the laptop does not see the port, and serial monitor shows nothing.
In the sketch I used,
in setup
Serial.begin(115200);
Serial5.begin(115200);
in the loop
Serial5.println(OutputShoulder);
Thanks
So I need to monitor the behavior of my motors and encoders through SerialPlotter or processing. Therefore I need another USB port just for that , and I selected 5, since is not wired to any of my needs.
From the laptop USB I brought Plus Minus, RX TX and connected them accordingly. RX and TX go to 34 and 33. However the laptop does not see the port, and serial monitor shows nothing.
In the sketch I used,
in setup
Serial.begin(115200);
Serial5.begin(115200);
in the loop
Serial5.println(OutputShoulder);
Thanks