Question about the XenGi's KiCAD library

[MickPF]

Hello,

I take the KiCAD library of XenGi to use the footprint of Teensy 3.6, but I doubt the coordinates of the pins 58 to 62, especially relative to coordinates of the pin 1: They do not fit into any usual grid like 1/20", 1/40" etc.
Can someone please confirm that the library of XenGi contains correct coordinates of these pins?

Thanks in advance,
Michael

 

[lorenzofattori]

If I remember correctly I used XenGi's libraries for both schematic and PCB.
I printed out my PCB and seems fine, at least on the externals rows of pins.

The under pins are set as thru hole pins, so be careful they will be printed when you do the PCB