Teensy 3.5/3.6 header pin height

[Richard Graham]

I was wondering if I could find out the length of the header pins currently used on the Teensy 3.5/3.5 if I order the board with pins. (Or the part number for the headers).

I wasn't able to find this in the dimensional drawings on the PJRC website.

 

[manitou]

like these https://www.pjrc.com/store/header_14x1.html

 

[Richard Graham]

Yes, like these. The page doesn't give the length of the pins or manufacturers part number. There are at least 3 different 'standard' lengths available from the usual component suppliers.

 

[manitou]

i measure the long leg at 0.25"
https://electronics.stackexchange.com/questions/77910/standard-length-of-male-header-pins

 

[Richard Graham]

Great, thanks for the quick response. So that is 0.25" for the "C" length, from the top of the plastic to the end of the pin?

 

[PaulStoffregen]

Below the board, the plastic is 0.1 inch, and the pin extends 0.25 inch below the plastic.