paoloboatto
Member
I'm using a Teensy 3.6 board connected to a nRF24L01+ module. I'm using the nRF library and it works perfectly with the following hardware connections:
If I change the Chip Enable and the Chip Select pins as follows:
it doesn't work. I tried to configure those pins as output but with no success.
What am I missing?
- CE (Chip Enable) = 9
- CSN (Chip Select) = 10
- MOSI = 11
- MISO = 12
- SCK = 13
If I change the Chip Enable and the Chip Select pins as follows:
- CE = 2
- CSN = 15
it doesn't work. I tried to configure those pins as output but with no success.
What am I missing?