Hi,
My Teensy3.6 arrived in the mail today and I thought I gave it a spin.
Unfortunately the led is not blinking when I connect the Teensy to my PC. I have not uploaded a sketch before.
I double checked the following:
- the usb cable is fine, I used the same cable to connect to an Arduino Due and my PC detected it right away
- I'm using Linux as a development environment. I'm not seeing the Teensy being enumerated at all, I'm using lsusb to test this. I plugged/unplugged several times, I also waited a bit after connecting.
- I hooked up a scope to the 3.3V pins, the scope is measuring correctly 3.3 V.
The only explanation I could think of is that I fried the board while soldering the header pins.
Then again I used a professional soldering station, didn't put the temperature to high...
Any ideas what do next? Ship it back?
Many thanks in advance,
Klaas.
My Teensy3.6 arrived in the mail today and I thought I gave it a spin.
Unfortunately the led is not blinking when I connect the Teensy to my PC. I have not uploaded a sketch before.
I double checked the following:
- the usb cable is fine, I used the same cable to connect to an Arduino Due and my PC detected it right away
- I'm using Linux as a development environment. I'm not seeing the Teensy being enumerated at all, I'm using lsusb to test this. I plugged/unplugged several times, I also waited a bit after connecting.
- I hooked up a scope to the 3.3V pins, the scope is measuring correctly 3.3 V.
The only explanation I could think of is that I fried the board while soldering the header pins.
Then again I used a professional soldering station, didn't put the temperature to high...
Any ideas what do next? Ship it back?
Many thanks in advance,
Klaas.