educa
Active member
Hi and sorry if my question seems very easy.
I just want to connect a couple of buttons to a teensy and be able to do a digitalRead.
But... it is on a teensy 3.6
I searched the website and found some info about the obvious pulling up or down of a signal , but I think most of these are for AVR-based teensy pcbs
Therefore, I'd rather first ask before I possibly break my 3.6
Does 3.6 have internal pullups and do I init them the same way like with the avr based teensy's ? I believe if that would be the case, then I just have to set the pin as input and enable that pullup somehow and then connect my button to that pin and to ground like on regular avrs ?
Kind regards,
Bart
I just want to connect a couple of buttons to a teensy and be able to do a digitalRead.
But... it is on a teensy 3.6
I searched the website and found some info about the obvious pulling up or down of a signal , but I think most of these are for AVR-based teensy pcbs
Therefore, I'd rather first ask before I possibly break my 3.6
Does 3.6 have internal pullups and do I init them the same way like with the avr based teensy's ? I believe if that would be the case, then I just have to set the pin as input and enable that pullup somehow and then connect my button to that pin and to ground like on regular avrs ?
Kind regards,
Bart