I would like to use pin 13 (the LED on the teensy) in my sketch that will use the audio board. Will that be a problem? I see it and another pin go to tx/rx inputs on the audio chip but the paths have pads to cut that would disconnect them. I will use just one audio board and the LED would make the user interface easier.
Also are there any issues with using the bounce library with a couple push buttons and the audio board to be aware of? I was thinking any interrupts could mess up the audio playing.
Also are there any issues with using the bounce library with a couple push buttons and the audio board to be aware of? I was thinking any interrupts could mess up the audio playing.