Pin bank mapping on Teensy 3.5/3.6?

Status
Not open for further replies.

foobar123

New member
For a project, I need at least 3 complete pin banks. They will be used for parallel communication with a z80 cpu and a ram chip. (1 byte data bus and 2 bytes address bus). Currently i am using an Arduino Mega, which has 4 complete pin banks, but runs at only 16mhz. So basically my question is, could i upgrade my project to use a teensy 3.5/3.6?

From the info i gathered, the teensy 3.2 only has 2 complete pin banks.
 
Status
Not open for further replies.
Back
Top