Hello everyone,
I'm currently working on a MIDI project with the Teensy 3.2.
I just finished implementing MIDI clock sync. However while developing two question came to my mind and I would like to know if someone can help me on them:
1. I use Ableton Live as DAW (as clock source). In the picture below you see the status bar of the clock in Ableton. The orange square at the bottom left corner indicates that right now there's a 1/4th tick of the clock. My teensy syncs to that. However above you can see a grey square which I highlighted in yellow. On all proper MIDI devices that I'm using with my DAW this is lighting up like a feedback for the clock of the MIDI device. I now ask myself how I can possibly trigger this feedback from within the Teensy (so both lights blink in the same time). I'm not very deep into MIDI messages that's why I might just not know which kind of message the DAW expects to receive.
2. Is it possible that the
event is triggered with a little delay? Because my clock runs quiet nicely in sync. However the first beat (the start) is always a little delayed. Like a 1/32th or so.
Thanks already for you help!
I'm currently working on a MIDI project with the Teensy 3.2.
I just finished implementing MIDI clock sync. However while developing two question came to my mind and I would like to know if someone can help me on them:
1. I use Ableton Live as DAW (as clock source). In the picture below you see the status bar of the clock in Ableton. The orange square at the bottom left corner indicates that right now there's a 1/4th tick of the clock. My teensy syncs to that. However above you can see a grey square which I highlighted in yellow. On all proper MIDI devices that I'm using with my DAW this is lighting up like a feedback for the clock of the MIDI device. I now ask myself how I can possibly trigger this feedback from within the Teensy (so both lights blink in the same time). I'm not very deep into MIDI messages that's why I might just not know which kind of message the DAW expects to receive.
2. Is it possible that the
Code:
usbMIDI.setHandleStart(myStart);
Thanks already for you help!
Last edited: