Hi everybody,
I am trying to control an DAC (MAX532 BEPE) from Teency 3.5.
I have tryed both the unipolar and bipolar connections as reported in the datasheet:https://datasheets.maximintegrated.com/en/ds/MAX532.pdf
using the code at the following link:
https://www.arduino.cc/en/Tutorial/DigitalPotControl
(I have only changed the pin numbers to make properly connections with Teency 3.5)
I am powering the circuit by means of a CUI INC DC/DC converter PYB30-Q24-T515
https://www.arrow.com/en/products/pyb30-q24-t515/cui-inc
I can't read anything from the output of the DAC with the scope and I think one DAC get burned.
Do you have any suggestions?
Thank you
I am trying to control an DAC (MAX532 BEPE) from Teency 3.5.
I have tryed both the unipolar and bipolar connections as reported in the datasheet:https://datasheets.maximintegrated.com/en/ds/MAX532.pdf
using the code at the following link:
https://www.arduino.cc/en/Tutorial/DigitalPotControl
(I have only changed the pin numbers to make properly connections with Teency 3.5)
I am powering the circuit by means of a CUI INC DC/DC converter PYB30-Q24-T515
https://www.arrow.com/en/products/pyb30-q24-t515/cui-inc
I can't read anything from the output of the DAC with the scope and I think one DAC get burned.
Do you have any suggestions?
Thank you