Simple question.

Does the i2c_t3 library support I2C restart conditions? I have an I/O expander that you need to set the register address you want to start the read from (I2C Write), do a Restart, then do an I2C Read for however many bytes you need.

It wasn't clear to me in the library documentation what I2C_NOSTOP means for the Wire.sendTransmission(^i2c_stop) fuction.

With the Arduino Wire library Wire.endTransmission() explicitly says it will do a restart if you pass it a 0.

I'd assume they'd behave the same way, but just want to make sure.

Thanks!