Hi there. Very new here (not new to Teensy's in general, but) so sorry if this is the wrong place. Also sorry if this has been asked before - I searched "PCB", "PCB mount", "teensy PCB" etc and couldn't find anything specific.
I want to mount my Teensy to a PCB. I've done this in the past for an ECG Wave Amplifier & Display project, however I just used female headers and placed it in. This time, I want to surface-mount it (using paste and reflow oven obviously), for two reasons. The first being access to the USB line (as the project will be in an enclosure which has an external USB port already mounted), so I can breakout from this and send the tracks to the already existing USB port as programming on the go is a must; the second being access to a few extra IO pins which is always handy.
Any tips on doing this? Is there dimensions I can find somewhere so I can make the appropriate footprint? And are there any forseable problems?
Thank you!
I want to mount my Teensy to a PCB. I've done this in the past for an ECG Wave Amplifier & Display project, however I just used female headers and placed it in. This time, I want to surface-mount it (using paste and reflow oven obviously), for two reasons. The first being access to the USB line (as the project will be in an enclosure which has an external USB port already mounted), so I can breakout from this and send the tracks to the already existing USB port as programming on the go is a must; the second being access to a few extra IO pins which is always handy.
Any tips on doing this? Is there dimensions I can find somewhere so I can make the appropriate footprint? And are there any forseable problems?
Thank you!