I'd like to use the pins on the underside of the Teensy 3.6. These would be digital pins 40-57. The goal would be to have the Teensy be a duaghter board to a larger main board.
It looks like I could use a surface mount header. But what would the spacing be?
Looking at say Pin 46 would it be 0.3" from Pin 31? And then Pin 47 would be another 0.1" for a total of 0.4" from Pin 31?
It seems like that would be the case, but I don't have calipers or anything to measure tenths of an inch.
If anyone knows what length headers, that would be very helpful too...
Thanks!
It looks like I could use a surface mount header. But what would the spacing be?
Looking at say Pin 46 would it be 0.3" from Pin 31? And then Pin 47 would be another 0.1" for a total of 0.4" from Pin 31?
It seems like that would be the case, but I don't have calipers or anything to measure tenths of an inch.
If anyone knows what length headers, that would be very helpful too...
Thanks!