agustin
New member
Hi friends. I´m new to the Teensy world but not on other MCUs.
I wanted to build a simple cockpit panel to control trims and radiators with slider pots. I hooked up a pot on a slider axis using the example sketch on Arduino, and all the sliders on joystick properties are wobbling like crazy. All other analog pins aren´t hooked to anything. But the pin where a pot is hooked still has some wobbling. Is this caused by floating voltage by induced eletromagnetic fields such as AC from the outlets for example? Should I attach the pins to VCC, GND with a resistor? What value should I use? I haven´t tried that yet since I´m not at home. anyways thank you to all!
I wanted to build a simple cockpit panel to control trims and radiators with slider pots. I hooked up a pot on a slider axis using the example sketch on Arduino, and all the sliders on joystick properties are wobbling like crazy. All other analog pins aren´t hooked to anything. But the pin where a pot is hooked still has some wobbling. Is this caused by floating voltage by induced eletromagnetic fields such as AC from the outlets for example? Should I attach the pins to VCC, GND with a resistor? What value should I use? I haven´t tried that yet since I´m not at home. anyways thank you to all!