Hi,
I just recently switched to Teensy from Arduino Due.
Now when i program teensy 3.6 with USB power (external power disconnected).
Code gets exicuted perfectly.
Than i disconnect USB and connect extrenal power to VIN and ANALOG GROUND. Now the code does not get executed.
Is there something that i need to do so Teensy remembers the code? Or? When checking with multimeter theensy is powered!
I have read a lot of posts on this forum but they al relate to using External power and USB. Cutting the Vin and USB on the bottom or the red wire of the usb.
But is it possible to do it like above?
tnx for the help. Any comment is welcom!
N
I just recently switched to Teensy from Arduino Due.
Now when i program teensy 3.6 with USB power (external power disconnected).
Code gets exicuted perfectly.
Than i disconnect USB and connect extrenal power to VIN and ANALOG GROUND. Now the code does not get executed.
Is there something that i need to do so Teensy remembers the code? Or? When checking with multimeter theensy is powered!
I have read a lot of posts on this forum but they al relate to using External power and USB. Cutting the Vin and USB on the bottom or the red wire of the usb.
But is it possible to do it like above?
tnx for the help. Any comment is welcom!
N