willie.from.texas
Well-known member
Yes Theremingenieur, I agree. Too bad about the lack of DAC interface. The ADC's are only 12-bit resolution so that is going in the wrong direction as well.
Paul, after reviewing the manual I wanted to ask you to consider the possibility of bringing out enough signals to support the Camera Serial Interface (CSI). From the IMXRT1050RM manual, Table 19-1 defines the external signals, and the bottom paragraph of page 796 defines the signals required to support 8-bit, 10-bit, 16-bit and dual 8-bit connections. If I am reading the ALT-4 column of your table correctly, you are already bringing out most of the required signals for 8-bit operation. The only signal I think you would have to add is CSI-PIXCLK. See Sections 19.4.2, 19.4.3 and 19.4.4 for the three modes of operation.
Thanks -W
Paul, after reviewing the manual I wanted to ask you to consider the possibility of bringing out enough signals to support the Camera Serial Interface (CSI). From the IMXRT1050RM manual, Table 19-1 defines the external signals, and the bottom paragraph of page 796 defines the signals required to support 8-bit, 10-bit, 16-bit and dual 8-bit connections. If I am reading the ALT-4 column of your table correctly, you are already bringing out most of the required signals for 8-bit operation. The only signal I think you would have to add is CSI-PIXCLK. See Sections 19.4.2, 19.4.3 and 19.4.4 for the three modes of operation.
Thanks -W