anuragm.ec2018
Member
Hello Everyone,
I am trying to give the input through serial monitor to the variables and writing that values in the EEPROM. I am able to read and write from EEPROM on teensy 3.6.
according to the code it should read the value from EEPROM after booting up. But it is not reading from EEPROM. if i connect usb and write the code I can see the output but if I remove the usb and connect it again i dont see the output.
I have used ARDUINO _IDE to program teensy.
Thank you
Anurag
I am trying to give the input through serial monitor to the variables and writing that values in the EEPROM. I am able to read and write from EEPROM on teensy 3.6.
according to the code it should read the value from EEPROM after booting up. But it is not reading from EEPROM. if i connect usb and write the code I can see the output but if I remove the usb and connect it again i dont see the output.
I have used ARDUINO _IDE to program teensy.
Thank you
Anurag