Hi,
I recently got started on my new Teensy 3.6 and I tried running the HelloSerialMonitor example, then I opened the serialmonitor on the Arduino IDE. The output froze after a few lines of "hello world" and the window wouldn't close until I press the reboot button on the Teensy.
The code I used:
Output from the serial monitor when it frooze:
I tried using "cat /dev/ttyACM0", it still freezes after 20-30 lines output. Sometimes it just outputs one line of "Hello world " and closes.
If I kept rebooting, every 5th or 6th time the serial monitor would work, but "cat /dev/ttyACM0" would either freeze or exit.
system and software specs:
host operating system : Ubuntu 18.04
Arduino 1.8.5
Any suggestions to fix this problem would be appreciated.
I recently got started on my new Teensy 3.6 and I tried running the HelloSerialMonitor example, then I opened the serialmonitor on the Arduino IDE. The output froze after a few lines of "hello world" and the window wouldn't close until I press the reboot button on the Teensy.
The code I used:
Code:
void setup() {
Serial.begin(38400);
}
void loop()
{
Serial.println("Hello World");
delay(1000);
}
Output from the serial monitor when it frooze:
I tried using "cat /dev/ttyACM0", it still freezes after 20-30 lines output. Sometimes it just outputs one line of "Hello world " and closes.
If I kept rebooting, every 5th or 6th time the serial monitor would work, but "cat /dev/ttyACM0" would either freeze or exit.
system and software specs:
host operating system : Ubuntu 18.04
Arduino 1.8.5
Any suggestions to fix this problem would be appreciated.