Hey all,
I'm adding everything and the kitchen sink to my Teensy, and I've realized I'm rapidly running out of pins. Right now I have the Teensy 3.2 + Prop Shield + TeensyView + (a lot of inputs), and I'm now trying to add a BLE module to it. I need pin 20 for Serial 1, but it is currently being used by the TeensyView for CS. Following the Sparkfun guide below, it stated I needed to use pin 20 if I was using the prop shield instead of the standard pin 10.
https://learn.sparkfun.com/tutorials/teensyview-hookup-guide (1/5 of the way down)
The thing is, looking at the prop shield guide and circuit diagram, it doesn't seem to use pin 10:
https://www.pjrc.com/store/prop_shield.html
Am I misreading the Prop Shield page? If not, this solves a huge problem for me. Thanks!
Austin
I'm adding everything and the kitchen sink to my Teensy, and I've realized I'm rapidly running out of pins. Right now I have the Teensy 3.2 + Prop Shield + TeensyView + (a lot of inputs), and I'm now trying to add a BLE module to it. I need pin 20 for Serial 1, but it is currently being used by the TeensyView for CS. Following the Sparkfun guide below, it stated I needed to use pin 20 if I was using the prop shield instead of the standard pin 10.
https://learn.sparkfun.com/tutorials/teensyview-hookup-guide (1/5 of the way down)
The thing is, looking at the prop shield guide and circuit diagram, it doesn't seem to use pin 10:
https://www.pjrc.com/store/prop_shield.html
Am I misreading the Prop Shield page? If not, this solves a huge problem for me. Thanks!
Austin