Is it ok to have 3 Teensy 3.5 connected to a USB hub and flash each one by selecting it in Arduino by its USBBModem name,
or should I only have one connected at a time when updating?
I'm sure I had an odd issue yesterday when I went to update the boards.
Selected the correct port in Arduino,and Teensy loader did its thing OK.
When I went to select the serial monitor for that board I'm sure it hadn't updated.
In the end I wasn't sure what was happening, so I flashed them all separately, which worked ok
However, these Teensy will be difficult to get at when I've finished my project
so just want to be sure I'm not doing something wrong.
I'm on Mac OS 10.12.6, Arduino 1.85 TeensyDuino 1.41
TIA.
or should I only have one connected at a time when updating?
I'm sure I had an odd issue yesterday when I went to update the boards.
Selected the correct port in Arduino,and Teensy loader did its thing OK.
When I went to select the serial monitor for that board I'm sure it hadn't updated.
In the end I wasn't sure what was happening, so I flashed them all separately, which worked ok
However, these Teensy will be difficult to get at when I've finished my project
so just want to be sure I'm not doing something wrong.
I'm on Mac OS 10.12.6, Arduino 1.85 TeensyDuino 1.41
TIA.
