Hi everyone,
right now I´m using a quite large shield for my project with a Arduino Mega. On this shield are multiple other smaller shields connected, that are all basically produced to work with the 5V of the Mega.
I know that the Teensy 3.5 is capable of 5V. I´m not sure if the 3.6 is, but from what I read it is not.
Any way I would like to upgrade, but kind of use my shield. Ofc the code might be changed.
So of cause I could look out or kind of work through the pain of producing a adapter shield for the 3.5 and not worry so much about the 3V-5V thing, but maybe it would be needed to get a little bit more computing power than the 3.5 has.
Therefore my question :
Is there a adapter board/shield for the 3.6 "to" Arduino Mega ?
If not is it something quite difficult. I have no clue since I haven´t dive into it.
Regards and thank you !
right now I´m using a quite large shield for my project with a Arduino Mega. On this shield are multiple other smaller shields connected, that are all basically produced to work with the 5V of the Mega.
I know that the Teensy 3.5 is capable of 5V. I´m not sure if the 3.6 is, but from what I read it is not.
Any way I would like to upgrade, but kind of use my shield. Ofc the code might be changed.
So of cause I could look out or kind of work through the pain of producing a adapter shield for the 3.5 and not worry so much about the 3V-5V thing, but maybe it would be needed to get a little bit more computing power than the 3.5 has.
Therefore my question :
Is there a adapter board/shield for the 3.6 "to" Arduino Mega ?
If not is it something quite difficult. I have no clue since I haven´t dive into it.
Regards and thank you !