We (my son & me) are now owners of an 3D-Printer (cheap "ANET A8") . Setup and calibration was a pain - added some steel angles and a wooden board from the hardware store and now it prints OK, surprisingly good quality.
The original firmware was not that good and very slow, and we installed Marlin. The board uses an AVR and a simple 4-line display.
So.... next wish is to use a faster Teensy, a better display, better knobs, and encoders
According to the readme, Marlin 2 is already Teensy compatible - so...
I'm looking for a board and/or schematic for Teensy, Marlin-compatible.
The original firmware was not that good and very slow, and we installed Marlin. The board uses an AVR and a simple 4-line display.
So.... next wish is to use a faster Teensy, a better display, better knobs, and encoders
According to the readme, Marlin 2 is already Teensy compatible - so...
I'm looking for a board and/or schematic for Teensy, Marlin-compatible.
Last edited: