defragster
Senior Member+
@defragster - Running your version of the sketch now...
In order to make it easier to read without magnifier, I changed setTextSize(2) instead of 1
I just screwed up and was thinking I was plugging in my USB to Serial adapter to my PC, but instead to wall wart (power for RPI3) and for some reason the Adafruit board started to show magic smoke... So now I am going into my parts and grabbing a different converter. Maybe Sparkfun FTDI Basic 3.3v version...
I had your version hang once... Did not have button hooked up nor other serial port... Current run > 88000
Need to setup the sparkfun hunit... Not sure if I will put on Serial1 or Serial4...
Kurt - see updated post above - all seems well!
And stop using those old school fangled gadgets - just break out a Teensy or two for SerMon Echo!
Larger font - DOH - that would be nice - Current run over 50K
SerMon and T4 USB ODDITIES
<edit>: Another Flakes run to 26K then I decided to unplug HUB with 3 Teensy's - SerMon and TLoader off and three windows of TyComm open - plugged in and up and running - no ODD/dead T4. And Flakes up and running at 10+K NOTE: IDE port/Teensy shows T4 and one T_3.1 but not the other T_3.1 now after the Hub cycle
<edit> Just confirmed with Two Hubs - Amazon Basics USB 3 and a USB 2 Rosewill:
>> Connect HUB unit with T4 and two SerMon ECHO T_3.1's running and it works.
>> Plug/Power Each T_3.1 and Windows 'welcomes' them. Then plug the T_4 and NOTHING.
Need to revisit this with new T4 USB update
Last edited: