RWTH_MASCHI
Member
Hey,im having trouble getting my SPI devices to work properly.
My situation:
I need to connect 6 As5048a to my teensy 3.5 to read angle values. to accomplish this I use a simple library : https://github.com/ZoetropeLabs/AS5048A-Arduino
and this works fine if i have only one sensor connected to my teensy.
but it just doesnt work if i have more than one connected and i cant figure out why, i thought i just solder all MOSI MISO CLK 5V GND pins together from my sensors, (like this: https://www.youtube.com/watch?v=_p6m2WwF2Jk )
and connect those to my teensy, but it wont work.
and by it wont work i mean that i dont get correct angle values. its then just 0 all the time
has someone done this before and might tell me how? it seems so simple but i cant get it to work
My situation:
I need to connect 6 As5048a to my teensy 3.5 to read angle values. to accomplish this I use a simple library : https://github.com/ZoetropeLabs/AS5048A-Arduino
and this works fine if i have only one sensor connected to my teensy.
but it just doesnt work if i have more than one connected and i cant figure out why, i thought i just solder all MOSI MISO CLK 5V GND pins together from my sensors, (like this: https://www.youtube.com/watch?v=_p6m2WwF2Jk )
and connect those to my teensy, but it wont work.
and by it wont work i mean that i dont get correct angle values. its then just 0 all the time
has someone done this before and might tell me how? it seems so simple but i cant get it to work