massahwahl
Active member
Hello all,
I am working on building an 8 channel mixer based on the design of the attenuation version of the mixer schematic here. What I would like to do is use the teensy as an effects module post fader but i am not sure how to hook it up as such and i am getting conflicting info online. Is it possible at all to do this? My thought was to run each input into the teensy prior to the Op-Amp stage where I would be able to select and control an effect and then output each signal to the Op-Amps. After looking into the Teensy more and trying to understand how audio works with it I am led to believe that I may not even need Op-Amps at all?
Any help would be greatly appreciated!
I am working on building an 8 channel mixer based on the design of the attenuation version of the mixer schematic here. What I would like to do is use the teensy as an effects module post fader but i am not sure how to hook it up as such and i am getting conflicting info online. Is it possible at all to do this? My thought was to run each input into the teensy prior to the Op-Amp stage where I would be able to select and control an effect and then output each signal to the Op-Amps. After looking into the Teensy more and trying to understand how audio works with it I am led to believe that I may not even need Op-Amps at all?
Any help would be greatly appreciated!