m-16
Well-known member
Good afternoon.
Could you give a little help?
Unable to run project.
When you turn on and power from the USB, the computer sees the device as a HID-Compilant and USB Input Device.
Upload a sketch does not give.
Teensy side is assembled by option in the attached file.
Tell me please, is only one, the assembled project according to this concept is correct?
A question that is not clear to me and I could not find the answer in the datasheet.
If there is no connection between Pin 27 (USB1_VBUS) and Pin 22 (VREG_IN0), will the device remain operational and load-capable or substantial.
I would be glad of any help and help.
Thank you very much in advance.
Could you give a little help?
Unable to run project.
When you turn on and power from the USB, the computer sees the device as a HID-Compilant and USB Input Device.
Upload a sketch does not give.
Teensy side is assembled by option in the attached file.
Tell me please, is only one, the assembled project according to this concept is correct?
A question that is not clear to me and I could not find the answer in the datasheet.
If there is no connection between Pin 27 (USB1_VBUS) and Pin 22 (VREG_IN0), will the device remain operational and load-capable or substantial.
I would be glad of any help and help.
Thank you very much in advance.