bhavitrajput
Member
I am using the teensy 3.6 board.
I want to flash my firmware through boot-loader codes so I flashed example boot-loader code using MCUExpresso IDE, and want to flash my firmware at address 0x0000C000, but my firmware is written in Arduino IDE and I want to change the flashing address to 0x0000C000. How can I change the flashing address in Arduino IDE for my firmware?
I am using Kinetis Flash tool for flashing my firmware through boot loader code but I am getting error "kStatusMemoryRangeInvalid", but if I tried to load sample led firmware build by MCUExpresso it's flashing without any problem.
I want to flash my firmware through boot-loader codes so I flashed example boot-loader code using MCUExpresso IDE, and want to flash my firmware at address 0x0000C000, but my firmware is written in Arduino IDE and I want to change the flashing address to 0x0000C000. How can I change the flashing address in Arduino IDE for my firmware?
I am using Kinetis Flash tool for flashing my firmware through boot loader code but I am getting error "kStatusMemoryRangeInvalid", but if I tried to load sample led firmware build by MCUExpresso it's flashing without any problem.